Load data for 9 mm Browning Court (.380 ACP) + .356 | 120gr | H&N RN HS

Recommended Powder(s): ReloadSwiss RS 12, Rottweil P 801

Load Specifications

(Use the Personalized Load Calculator below to adjust )

Bullet:	.356 \| 120gr \| H&N RN HS
Bullet Weight:	120gr \| 7.8g
Bullet Diameter:	0.356" \| 9.04mm
Bullet Length:	0.591" \| 15.0mm
Caliber:	9 mm Browning Court (.380 ACP) load data
Case Length (l3):	0.681" \| 17.3mm
Cartridge Length (C.O.L.):	0.969" \| 24.6mm
Seated Depth:	0.303" \| 7.7mm
Shank Seated Depth:	0.283" \| 7.2mm
Case Capacity:	12.2 Grains of Water \| 0.79 cm³
Primer Size:	Small Pistol (SP)
Max. allowed Pressure:	19580 psi \| 1350 bar
LID:	LID_B7444_C1213
Last updated:	2025-01-01

Load data for 70 loads in caliber 9 mm Browning Court (.380 ACP) with .356 | 120gr | H&N RN HS bullet and 35 powders such as ReloadSwiss RS 12, Rottweil P 801. The key underlying parameters are shown in the table above.

Important Notice: DO NOT go below Minimum Charge or above Maximum Charge unless there are reasons. Since xxlreloading.com has no control over the equipment and components used by the customer and the data used in connection with the website, any responsibility and liability for the results achieved is rejected. Also see our Terms of Service.

Questions regarding the load data: Please read the information in the next tab "Explanations".
A load must fulfill certain criteria to be listed in the default view below - see "powder criteria to fulfill to be listed".

Our load data might deviate from other sources - see the "most common reasons for deviations".

All loads are based on the bullet and case dimensions shown under "Load Specifications" - see "reloading suggestions" if you deviate.

You can set your specifications in the "Personalized Load Calculator".

Go to the bottom of the "Dashboard " page to set the measure system (imperial vs. metric)
No data yet
C.O.L. (Inch)
C.O.L. (mm)
We recommend you limit powder range to relevant brands to speed up re-calculation of results
Use the Personalized Load Calculator to customize loads to your own specific requirements. Find more details in the help section.

Our default view only displays powders/loads that fulfill certain criteria: Max pressure of a load <=90% of Max. Standardized Pressure. Fill Rate (Min FR): >80% and <100% for rife loads, >60% and <100% for pistol loads. Min. Propellant Combustion (Min z): >90% for rifle loads , >80% for pistol/revolver loads. Relax these criteria at your own risk to potentially get more powders shown in the load tables.
Case Length (Inch)
Case Length (mm)
CaseCapacity (GoW)
Min z (%)
Min FR (%)
Max FR*
Barrel Length (Inch)
Barrel Length (cm)
Safety Buffer (%)
.

Click on the desired row in the tables below to add a specific load / powder to your Diary and manage there.

Powder	Charge	FR	MaxP	%	V(0)	z
ADI AP 70N	<<locked>>	83%	17143	88%	**9	95%
ADI APS 350	<<locked>>	73%	17390	89%	**1	100%
ADI APS 450	<<locked>>	74%	16389	84%	**1	100%
ADI AS 30	<<locked>>	81%	15127	77%	**4	100%
ADI AS 50N	<<locked>>	84%	16897	86%	**3	98%
Accurate Solo 1000	<<locked>>	82%	17042	87%	**7	99%
Accurate Solo 1250	<<locked>>	93%	16041	82%	**7	92%
[Alliant BULLSEYE]*	<<locked>>	79%	16114	82%	**7	86%
[Alliant UNIQUE]*	<<locked>>	92%	13996	71%	**0	83%
Baschieri & Pellagri 100	<<locked>>	88%	16375	84%	**0	97%
Hodgdon Clays	<<locked>>	73%	17477	89%	**1	100%
Hodgdon Universal	<<locked>>	92%	17143	88%	**9	95%
Lovex S011	<<locked>>	72%	16636	85%	**4	94%
[Lovex S020]*	<<locked>>	90%	16708	85%	**6	89%
Maxam CSB 1	<<locked>>	94%	14924	76%	**4	91%
Maxam CSB 2	<<locked>>	92%	11516	59%	**7	95%
Maxam CSB 3	<<locked>>	91%	16708	85%	**7	97%
Maxam CSB 4	<<locked>>	86%	16824	86%	**3	99%
Maxam CSB 5	<<locked>>	77%	15113	77%	**1	100%
[Ramshot Silhouette]*	<<locked>>	80%	17172	88%	**6	82%
Ramshot Zip	<<locked>>	66%	16882	86%	**7	95%
ReloadSwiss RS 12 👍	<<locked>>	94%	17202	88%	**5	100%
[ReloadSwiss RS 20]*	<<locked>>	94%	13967	71%	**7	83%
Rottweil P 801 👍	<<locked>>	85%	17492	89%	**9	100%
[SNPE Vectan A0]*	<<locked>>	92%	15708	80%	**1	83%
SNPE Vectan BA 9	<<locked>>	85%	17172	88%	**7	90%
SNPE Vectan BA10	<<locked>>	69%	16360	84%	**1	100%
SNPE Vectan BA9 1/2	<<locked>>	92%	17477	89%	**6	93%
[Somchem MP200]*	<<locked>>	90%	17303	88%	**0	84%
[Somchem MS200]*	<<locked>>	91%	16259	83%	**0	86%
Vihtavuori N310	<<locked>>	66%	14620	75%	**4	100%
Vihtavuori N320	<<locked>>	89%	16476	84%	**6	99%
Vihtavuori N330	<<locked>>	96%	17608	90%	**2	96%
[Vihtavuori N340]*	<<locked>>	95%	16462	84%	**0	86%
Winchester 231	<<locked>>	74%	16882	86%	**7	95%

Max Load - Barrel Length: 5.50''

Powder	Charge	FR	MaxP	%	V(0)	z
[ADI AP 70N]*²	<<locked>>	59%	8035	41%	**9	82%
ADI APS 350	<<locked>>	66%	14402	74%	**6	100%
ADI APS 450	<<locked>>	60%	11356	58%	**3	100%
ADI AS 30	<<locked>>	68%	10530	54%	**9	98%
ADI AS 50N	<<locked>>	66%	10428	53%	**6	93%
Accurate Solo 1000	<<locked>>	63%	10254	52%	**3	93%
[Accurate Solo 1250]*	<<locked>>	76%	10124	52%	**6	84%
[Alliant BULLSEYE]*	<<locked>>	68%	11951	61%	**8	80%
[Alliant UNIQUE]*	<<locked>>	87%	12169	62%	**8	80%
Baschieri & Pellagri 100	<<locked>>	70%	10066	51%	**9	90%
Hodgdon Clays	<<locked>>	66%	14286	73%	**5	100%
[Hodgdon Universal]*	<<locked>>	65%	8035	41%	**9	82%
[Lovex S011]*	<<locked>>	62%	12140	62%	**9	89%
[Lovex S020]*	<<locked>>	75%	10646	54%	**5	81%
[Maxam CSB 1]*	<<locked>>	77%	9544	49%	**6	83%
[Maxam CSB 2]*	<<locked>>	74%	7237	37%	**6	86%
Maxam CSB 3	<<locked>>	73%	10385	53%	**2	91%
Maxam CSB 4	<<locked>>	68%	10182	52%	**2	94%
Maxam CSB 5	<<locked>>	64%	10443	53%	**9	100%
[Ramshot Silhouette]*	<<locked>>	76%	15156	77%	**0	80%
Ramshot Zip	<<locked>>	62%	14605	75%	**4	93%
ReloadSwiss RS 12	<<locked>>	68%	7774	40%	**5	92%
[ReloadSwiss RS 20]*	<<locked>>	88%	12125	62%	**4	80%
Rottweil P 801	<<locked>>	60%	7658	39%	**2	95%
[SNPE Vectan A0]*	<<locked>>	87%	13692	70%	**1	81%
[SNPE Vectan BA 9]*	<<locked>>	65%	9790	50%	**6	80%
SNPE Vectan BA10	<<locked>>	62%	13677	70%	**9	100%
[SNPE Vectan BA9 1/2]*	<<locked>>	70%	9732	50%	**6	83%
[Somchem MP200]*	<<locked>>	85%	15273	78%	**0	82%
[Somchem MS200]*	<<locked>>	80%	12430	63%	**8	81%
Vihtavuori N310	<<locked>>	60%	11748	60%	**5	100%
Vihtavuori N320	<<locked>>	65%	8238	42%	**6	91%
[Vihtavuori N330]*	<<locked>>	70%	8398	43%	**6	82%
[Vihtavuori N340]*	<<locked>>	84%	12299	63%	**5	80%
[Winchester 231]*	<<locked>>	60%	10834	55%	**5	88%

Start Load - Barrel Length: 5.50''

Any powder missing? Then click here.

FR ... fill rate of the cartridge in percent

MaxP ... max. pressure of load in psi or bar

% ... max. pressure of load in percent of the maximum allowed pressure for this caliber

V(0) ... muzzle velocity in feet per second (fps) or meters per second (m/s)

z ... powder burnt in percent

[...] *... not dangerous but load has suboptimal powder burnt with possible characteristics such as extensive muzzle flash or inaccurate loads.

[...] ²... fill rate low - you might want to consider using a filler to ensure proper ignition.

[...] ᴾ... possible press load - work up slowly to this load while watching for signs of excessive pressure.

👍 ... recommended powder/load for this caliber and bullet combination based on its ballistic performance.

<<locked>>... you need to buy an access license to unlock the data